The Texas Twin

Texas Twin Fin

I have been able to sand down much of the blocks on the nose and tail.  The project sat for a while, but I'm excited to be back in the shop again! 

Texas Twin Fin

I have been able to sand down much of the blocks on the nose and tail.  The project sat for a while, but I'm excited to be back in the shop again! 

Moving off of the rocker table and to the stands!

The rocker table serves a function for maintaining your rocker and balance in the board so the board doesn't twist. But eventually to get those bottom planks you have to move the board to the stands. I use the bar clamps because the boards of twisted in storage so I have to bend them back into place. I really prefer each blank to be clamped to eat rib eye just makes me feel like the board is going to be a stronger board and will last longer that way. Sometimes you will have ribs separate from the deck, but that happens after the glassing process.   Sometimes you can even feel it under your feet as you surf the board.  But by then the board is wrapped in glass and its never going to be an issue.

More pics of the frame

These are just a few more pics from this evening.

Preparing the Frame For sanding the rails flush

Tonight I had to support the tail run off peices.  I am letting the nose peices run a bit wild, but the tail needs to be strong and manageable when it comes to mounting ornamental bits.

Rail Method: Bead n Cove

I am almost finished with building the rails on thisb 8 foot fish.  It's a slow process.  If I  use gorilla glue, I can fit 2 to 3 gluing sessions in (morning, afternoon, night) becuase it dries just that fast.  The down side is that its an expanding glue and you have to clean up sections that expand and get in the way of the next lamination.  I used Tightbond Type III waterproof glue this time and found I could laminate in 12 hour repetitions.  This is where I am at with one more repetition left.

Tooling and Techniques

I tend to make one more year  maybe two. It feels good to be using some techn iques in the new project that continue to work for me.  For each step along the way whether it milling or application it always feels second nature to me to question and wonder if there's a better way of doing things. I think this is my 12 board and several things are coming back to me that I would not change.

Whether it is working with a table saw or a router table feather boards are always very helpful especially when working with thin quarter inch thick material.

I am always grateful when I can get to my first being co strip because the frame gets incrementaly stronger with each gluing.